RAID mode setup / LED display statusRAID Mode Selection3CONTENTVersion 1.3QUICK INSTALLATION GUIDEQuick Installation Guide4Overview1LED indicationRAID
Mirroring (RAID 1) - 1 New Simple Volume Disk Initialization1718
Before connecting to the Macintosh, please refer to the Hard Drive Assembly Procedures for RAID set-up. If HDD is pre-installed by our vendor, user ca
21Macintosh SystemRemove the “external hard drive” from Macintosh...• Drag the Ext Hard Disk to trash bin. • Unplug USB and remove the power adapter.N
Detail ViewFront View 1. Power / Sleep indicator 2. Rebuild indicator 3. HDD1 Access Indicator 4. HDD2 Access Indicator 5. HDD1 Error Indicator 6. HDD
RAID Mode SelectionUsers should set up the RAID mode when the device is powered off.SW1RAID Mode SW (3)Single( Non - RAID )Single( Non - RAID )Stripin
C. Insert HDD1 and HDD2 into HDD rack and secure them with screws provided. E. Select the RAID mode via DIP switch referring to manual on pag
RAID 0 JBOD (Spanning) MODERAID 0 - Striping: Two HDDs will show up as one large single drive but speed performance will boost up. The two HDDs wil
Macintosh SystemMinimum Requirements: • Minimum Apple G4 processor , 128MB RAM• e-SATA :With support for Port-Multiplier function • USB 2.0 equipped M
Microsoft Windows InstallationDisk InitializationSingle mode (Non-RAID) - 2 New Simple VolumesNew simple volume / PartitionSingle Mode - New simple vo
Spanning and Striping (RAID 0) - 1 New Simple VolumeDisk InitializationIf Spanning or Striping mode capacity above 2TB, please refer to Microsoft Wind
Disk Initialization1516
Kommentare zu diesen Handbüchern